Universal Remote Control TOTAL CONTROL FX-1 Istruzioni per gli Interventi

POLAR-CONTROLLERTM Operating Instructions P/N 100101 (120 VAC) P/N 100106 (230 VAC)

9 2. DMX Addressing Each DMX’d unit will occupy a unique DMX address on the DMX chain. By adjusting the dip switches on the side of the fog machine

10 0 – 49% = Off 50 – 100% = On 6. Service and Maintenance 6.1 Emptying the tray Take care to be sure drip pan is in place. Empty it

11 7. Technical Data Polar ControllerTM Technical Data P/N 100101 (230V P/N 100106) Type of Fog Thick, white, dry, low-ground fog Weight w/fogger

12 8. Limited Warranty Conditions This limited warranty guarantees to the original purchaser that this product shall be free of defects in mat

13 days of receipt, CITC will cover the cost of returning the repaired unit to the customer. 4. Limited warranty services do not cause an extension

1 Thank you for purchasing this POLAR CONTROLLERTM  As you will notice from the table of contents, the manual for your new product is quite ext

2 Contents 1. Set of Equipment Supplied 3 2. Accessories 3 3. Description 4

3 1. Set of Equipment Supplied  1 Polar ControllerTM w/DMX On board  1 Remote Control Unit  Double-hose outlet manifold  Two 5” X 8ft fog

4 3. Description of the POLAR CONTROLLERTM The POLAR CONTROLLERTM is CITC’s new low-ground fogging system. No CO2, no dry ice, and no separate fog m

5 5. Operating the POLAR CONTROLLERTM 5.1 Selecting the Location Secure a good location for the machine to rest solidly on the floor separated

6 position. Lay the tube along the floor keeping it on the floor away from any hot lights. Do not bend the tubes into sharp 90o angles. The straighte

7 backpressure and cause a buildup of residue. Backpressure can cause a severe amount of condensation and will create problems for you later on down t

8 o If the fog is wet this is usually caused by turning up the volume too high. Only operate at 100% (below blast on the remote control) or below 7